Vega VEGAFLEX 83 Modbus and Levelmaster protocol PFA in Uživatelský manuál Strana 59

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 96
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 58
59
9 Diagnostics and service
VEGAFLEX 83 • Modbus and Levelmaster protocol
41838-EN-130314
Code
Text mes-
sage
Cause Rectication PA DevS-
pec
Diagnosis
F125
Unper-
missible
electronics
tempera-
ture
Temperature of the
electronics in the non-
specied section
Check ambient tem-
perature
Isolate electronics
Use instrument with
higher temperature
range
Bit 8
F260
Error in the
calibration
Error in the calibra-
tion carried out in the
factory
Error in the EEPROM
Exchanging the elec-
tronics
Send instrument for
repair
Bit 9
F261
Error in the
congura-
tion
Error during setup
False signal suppres-
sion faulty
Error when carrying
out a reset
Repeat setup
Repeat reset
Bit 10
F264
Installa-
tion/Setup
error
Adjustment not within
the vessel height/
measuring range
Max. measuring range
of the instrument not
sucient
Check or correct
installation and/or
parameter adjustment
Use an instrument
with bigger measuring
range
Bit 11
F265
Meas-
urement
function
disturbed
Sensor no longer
carries out a measure-
ment
Operating voltage
too low
Check operating
voltage
Carry out a reset
Separate operating
voltage briey
Bit 12
F267
No execut-
able sensor
software
Sensor cannot start Exchanging the elec-
tronics
Send instrument for
repair
-
The following table shows the error codes and text messages in the
status message "Function check" and provides information on causes
as well as corrective measures.
Code
Text mes-
sage
Cause Rectication
C700
Simulation ac-
tive
A simulation is active Finish simulation
Wait for the automatic end
after 60 mins.
The following table shows the error codes and text messages in the
status message "Outofspecication" and provides information on
causes as well as corrective measures.
Function check
Outofspecication
Zobrazit stránku 58
1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 95 96

Komentáře k této Příručce

Žádné komentáře